Ipv6 Pim Query-Interval; Ipv6 Pim Register-Filter - Dell Force10 S4810P Reference Manual

ipv6 pim query-interval

Change the frequency of IPv6 PIM router-query messages.
E-Series, S4810
Syntax ipv6 pim query-interval seconds
To return to the default value, use the no ipv6 pim query-interval seconds
command.
Parameters
seconds
Defaults 30 seconds
Command Modes INTERFACE
Command History
Version 8.3.12.0
Version 7.4.1.0

ipv6 pim register-filter

Configure the source DR so that it does not send register packets to the RP for the specified sources and groups.
E-Series, S4810
Syntax ipv6 pim register-filter access-list
Parameters
access-list
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0
Version 8.3.1.0
Example
FTOS(conf)#ipv6 pim register-filter REG-FIL_ACL
FTOS(conf)#ipv6 access-list REG-FIL_ACL
FTOS(conf-ipv6-acl)#deny ipv6 165:87:34::10/128 ff0e::
225:1:2:0/112
FTOS(conf-ipv6-acl)#permit ipv6 any any
FTOS(conf-ipv6-acl)#exit
Enter a number as the number of seconds between router query
messages. The range is 0 to 65535. The default is 30 seconds.
Introduced on the S4810.
Introduced
Enter the name of the extended ACL that contains the sources and
groups to be filtered.
Introduced on the S4810.
Introduced
1261