Vlan-Stack Compatible - Dell Force10 S4810P Reference Manual

Usage
Prior to enabling this command, you must enter the switchport command to place the
Information
interface in Layer 2 mode.
To remove the access port designation, the port must be removed (using the no member
interface command) from all stackable VLAN enabled VLANs.

vlan-stack compatible

Enable the stackable VLAN feature on a VLAN.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, use the no vlan-stack compatible
command.
Defaults Not configured.
Command Modes CONF-IF-VLAN
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.6.1.0
E-Series original
Command
Usage
You must remove the members prior to disabling the stackable VLAN feature.
Information
To view the stackable VLANs, use the show vlan command in EXEC Privilege mode.
Stackable VLANs contain members, designated by the M in the Q column of the command
output.
Example
FTOS#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
*
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
NUM Status Q Ports
1 Inactive
2 Active M Gi 13/13
M Gi 13/0-2
3 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/3
4 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/4
5 Active M Po1(Gi 13/14-15)
M Gi 13/18
1593