Debug Uplink-State-Group; Description - Dell Force10 S4810P Reference Manual

Related
Commands

debug uplink-state-group

Enable debug messages for events related to a specified uplink-state group or all groups.
S-Series (S50 only), S4810
Syntax debug uplink-state-group [group-id]
To turn off debugging event messages, enter the no debug uplink-state-group
[group-id] command.
Parameters
group-id
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.12.0
Version 8.4.2.3
Related clear ufd-disable
Commands

description

Enter a text description of an uplink-state group.
S-Series (S50 only), S4810
Syntax description text
Parameters
text
Defaults none
Command Modes UPLINK-STATE-GROUP
1578
• downstream – assigns a port or port-channel to the uplink-state group as a
downstream interface.
• uplink-state-group – creates an uplink-state group and enables the tracking of
upstream links.
Enables debugging on the specified uplink-state group. The valid
group-id values are 1 to 16.
Introduced on the S4810.
Introduced on the S-Series S50.
– re-enables downstream interfaces that are in a UFD-Disabled Error state.
Text description of the uplink-state group. The maximum length is 80
alphanumeric characters.