priority
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
pre-Version
6.1.1.1
Usage
Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
Information
ip pim sparse-mode
Enable PIM sparse mode and IGMP on the interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip pim sparse-mode
To disable PIM sparse mode and IGMP, use the no ip pim sparse-mode command.
Defaults
Disabled.
Command Modes
INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Usage
C-Series supports a maximum of 31 PIM interfaces.
Information
The interface must be enabled (the no shutdown command) and not have the
switchport command configured. Multicast must also be enabled globally (using the ip
multicast-lag-hashing command). PIM is supported on the port-channel interface.
Related
ip multicast-lag-hashing
Commands
1244
•
For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
(OPTIONAL) Enter the priority used in Bootstrap election process. The
range is zero (0) to 255. The default is 192.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the E-Series.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series for the port-channels and the S-Series.
– enables multicast globally.