disable
Enable or disable LLDP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
disable
To enable LLDP, use the no disable command.
Defaults
Enabled, that is no disable.
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Related
protocol lldp (Configuration)
Commands
debug lldp interface
show lldp neighbors
show running-config lldp
hello
Configure the rate at which the LLDP control packets are sent to its peer.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds
Defaults
30 seconds
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enables LLDP globally.
– debugs LLDP.
– displays the LLDP neighbors.
– displays the LLDP running configuration.
Enter the rate, in seconds, at which the control packets are sent to its
peer. The rate is 5 to 180 seconds. The default is 30 seconds.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
interface -lldp)
interface -lldp)
1073