Ipv6 Pim Sparse-Mode - Dell Force10 S4810P Reference Manual

Parameters
interface
priority-value
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0
Version 7.4.1.0

ipv6 pim sparse-mode

Enable IPv6 PIM sparse mode on the interface.
E-Series, S4810
Syntax ipv6 pim sparse-mode
To disable IPv6 PIM sparse mode, use the no ipv6 pim sparse-mode command.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version 8.3.12.0
Version 7.4.1.0
Usage The interface must be enabled (use the no shutdown command) and not have the
Information switchport command configured. Multicast must also be enabled globally. PIM is
supported on the port-channel interface.
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the E-Series, the range
is 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
(OPTIONAL) Enter a number as the priority of this RP Candidate,
which is included in the Candidate-RP-Advertisements. The range is 0
(highest) to 255 (lowest).
Introduced on the S4810.
Introduced
Introduced on the S4810.
Introduced
1263