Dell Force10 S4810P Reference Manual page 792

Output Statistics:
pkts
Rate info (interval 299 seconds):
Time since last interface status change: 3d17h51m
Usage
On the C-Series and S-Series, the interface counter "over 1023-byte pkts" does not increment
Information
for packets in the range 9216 > x < 1023.
The Management port is enabled by default (no shutdown). If necessary, use the ip
address command to assign an IP address to the Management port. If two RPMs are
installed in your system, use the show redundancy command to display which RPM is the
Primary RPM.
On the S4810 and Z9000, you can configure two global IPv6 addresses. To view the addresses,
use the show interface managementethernet command. If you try to configure a
third IPv6 address, a message displays. If auto-configuration is enabled, all IPv6 addresses on
that management interface are auto-configured. The first IPv6 address that is configured on
the management interface will be the primary address. If deleted, it must be re-added; the
secondary address is not promoted.
Example
FTOS#show interfaces tengigabitethernet 0/0
(TeraScale)
TenGigabitEthernet 3/0 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:41:77:c5
Pluggable media present, XFP type is 10GBASE-SR
Interface index is 134545468
Port will not be disabled on partial SFM failure
MTU 9252 bytes, IP MTU 9234 bytes
LineSpeed 10000 Mbit
Flowcontrol rx on tx on
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:15:14
Queueing strategy: fifo
Input Statistics:
byte pkts
pkts
Output Statistics:
pkts
pkts
wredDrops
792
0 CRC, 0 overrun, 0 discarded
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Current address is 00:01:e8:41:77:c5
Medium is MultiRate, Wavelength is 850.00nm
XFP receive power reading is -2.4834
4410013700 packets, 282240876800 bytes
0 Vlans
4410013700 64-byte pkts, 0 over 64-byte pkts, 0 over 127-
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
857732 packets, 54894848 bytes, 0 underruns
857732 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
24 Multicasts, 0 Broadcasts, 857708 Unicasts
0 Vlans,0 throttles, 0 discarded, 0 collisions, 4409143619