Vlt Domain; Vlt-Peer-Lag Port-Channel - Dell Force10 S4810P Reference Manual

Command Modes

VLT DOMAIN

Command History
Version 9.0.0.0
Version 8.3.8.0
Usage
When you create a VLT domain on a switch, FTOS automatically assigns a unique unit ID (0 or
Information
1) to each peer switch. The unit IDs are used for internal system operations. Use the unit-id
command to explicitly configure the unit ID of a VLT peer. You must configure a different unit ID
(0 or 1) on each peer switch.
Use this command to minimize the time required for the VLT system to determine the unit ID
assigned to each peer switch when one peer reboots.
vlt domain
Enable VLT on a switch, configure a VLT domain, and enter VLT-domain configuration mode.
Z-Series, S4810
Syntax vlt domain domain-id
Parameters
domain-id
Command Modes CONFIGURATION
Command History
Version 9.0.0.0
Version 8.3.8.0
Usage The VLT domain ID must be the same between the two VLT devices. If the domain ID is not the
Information same, a syslog message is generated and VLT does not launch.
Related show vlt
Commands

vlt-peer-lag port-channel

Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to an attached
device.
Z-Series, S4810
Syntax vlt-peer-lag port-channel id-number
1610
Introduced on the Z9000.
Introduced on the S4810.
Enter the Domain ID number. You must configure the same domain ID
on the peer switch. The range of domain IDs is 1 to 1000.
Introduced on the Z9000.
Introduced on the S4810.
– uses the show vlt brief command to display the delay-restore value.