Dell Force10 S4810P Reference Manual page 928

Command History
Version 8.4.2.1
Version 8.2.1.0
Version 7.8.1.0
Usage
This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when verifying QoS
Information
optimization for IPv6 ACLs.
QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a policy on a
single (or the first of several) interfaces. It is most useful when a policy is applied across
multiple interfaces; it can reduce the impact to CAM usage across subsequent interfaces.
The following describes the test cam-usage command shown in the Example below.
Term
Linecard
Portpipe
CAM Partition
Available CAM
Estimated CAM per
Port
Status
Example (C-
FTOS#test cam-usage service-policy input LauraMapTest linecard
Series)
all
Linecard|Portpipe|CAM Partition|Available CAM|Estimated CAM
per Port|Status
--------------------------------------------------------------
Allowed
Allowed
Allowed
Allowed
FTOS#
FTOS#test cam-usage service-policy input LauraMapTest linecard
4 port-set 0
Linecard|Portpipe|CAM Partition|Available CAM|Estimated CAM
per Port|Status
-------------------------------------------------------------
Allowed
Allowed
FTOS#
FTOS#test cam-usage service-policy input LauraMapTest linecard
928
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and E-Series TeraScale.
Explanation
Lists the line card or linecards that are checked. Entering all
shows the status for linecards in the chassis.
Lists the portpipe (port-set) or port pipes (port-sets) that are
checked. Entering all shows the status for linecards and port-pipes
in the chassis.
Shows the CAM profile of the CAM.
Identifies the amount of CAM space remaining for that profile.
Estimates the amount of CAM space the listed policy requires.
Indicates whether or not the policy is allowed in the CAM
2| 1| IPv4Flow|
2| 1| IPv6Flow|
4| 0| IPv4Flow|
4| 0| IPv6Flow|
4| 0| IPv4Flow|
4| 0| IPv6Flow|
232|
0|
232|
0|
232|
0|
0|
0|
0|
0|
0|
0|