Remark - Dell Force10 S4810P Reference Manual

remark

Enter a description for an IPv6 ACL entry.
C-Series, E-Series, S-Series
Syntax remark remark number [description]
To delete the description, use the no remark remark number command (it is not
necessary to include the remark description that you are deleting).
Parameters
remark number
description
Defaults Not configured.
Command Modes ACCESS-LIST
Command History
Version 8.4.2.1
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
Usage As shown in the Example below, the same sequence number is used for the remark and an ACL
Information rule. The remark precedes the rule in the running-configuration because it is assumed that the
remark is for that rule or that group of rules that follow the remark. You can configure up to
4294967290 remarks in a given ACL.
Example
FTOS(config-ipv6-acl)#remark 10 Remark for Entry # 10
FTOS(config-ipv6-acl)#show config
!
ipv6 access-list Acl1
bytes
!FTOS(config-ipv6-acl)#
Related show config
Commands
Enter the remark number. The range is 0 to 4294967290.
Enter a description of up to 80 characters.
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
description IPV6 Access-list
seq 5 permit ipv6 1111::2222/127 host 3333::1111 log count
remark 10 Remark for Entry # 10
seq 10 permit icmp host 3333:: any mobile-advertisement log
seq 15 deny tcp any any rst
seq 20 permit udp any any gt 100 count
– displays the current ACL configuration.
NOTE: You can use the same sequence number for the remark
and an ACL rule.
919