Show Ip Fib Linecard - Dell Force10 S4810P Reference Manual

show ip fib linecard

View all forwarding information base (FIB) entries.
C-Series, E-Series, S4810
Syntax show ip fib linecard slot-number [vrf vrf instance | ip-
address/prefix-list | summary]
Parameters
vrf instance
slot-number
ip-address mask
longer-prefixes
summary
Command Modes
Command History
Version 8.3.7.0
Version 8.1.1.0
Version 7.9.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show ip fib command shown in the Example below.
Information
Field
Destination
Gateway
First-Hop
(OPTIONAL) E-Series Only: Enter the keyword vrf followed by the
VRF instance name to show the FIB cache entries tied to that VRF
instance.
Enter the number of the line card slot. For the C-Series, the range is 0
to 7. For the E-Series, the range is 0 to 13 on a E1200, 0 to 6 on a E600/
E600i, and 0 to 5 on a E300.
(OPTIONAL) Enter the IP address of the network destination to view
only information on that destination. You must enter the IP address is
dotted decimal format (A.B.C.D). You must enter the mask in slash
prefix format (/X).
(OPTIONAL) Enter the keywords longer-prefixes to view all
routes with a common prefix.
(OPTIONAL) Enter the keyword summary to view the total number of
prefixes in the FIB.
• EXEC
• EXEC Privilege
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced VRF on the E-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Lists the destination IP address.
Displays either the word "direct" and an interface for a directly
connected route or the remote IP address to be used to forward the
traffic.
Displays the first hop IP address.
879