Iscsi Profile-Compellant; Iscsi Target Port - Dell Force10 S4810P Reference Manual

iscsi profile-compellant

Configure the auto-detection of Dell Compellent arrays on a port.
S4810
Syntax iscsi profile-compellent
Defaults Dell Compellent disk arrays are not detected.
Command Modes INTERFACE
Command History
Version 8.3.12.0
Version 8.3.16.0

iscsi target port

Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is monitored.
S4810
Syntax iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-
address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi target
port command.
Parameters
tcp-
port-2...tcpport-
16
ip-address
(Optional)
Defaults 860, 3260
Command Modes CONFIGURATION
Command History
Version 8.3.12.0
Version 8.3.16.0
Usage
You can configure up to 16 target TCP ports on the switch in one command or multiple
Information
commands.
When you use the no iscsi target port command and the TCP port to be deleted is
one bound to a specific IP address, the IP address value must be included in the command.
962
Introduced on the S4810.
Introduced on MXL 10/40GbE Switch IO Module.
Enter the tcp-port number of the iSCSI target ports. The tcp-port-
n is the TCP port number or a list of TCP port numbers on which the
iSCSI target listens to requests. Separate port numbers with a
comma. The default is 860, 3260.
Enter the ip-address that the iSCSI monitors. The ip-address specifies
the IP address of the iSCSI target.
Introduced on the S4810.
Introduced on MXL 10/40GbE Switch IO Module.