Mac-Address-Table Station-Move Threshold - Dell Force10 S4810P Reference Manual

vlan
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.1(0.0)
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Example mac-address-table static 00:01:00:00:00:01 {output Te 0/2 vlan
2}
(Unicast)
Example mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2
output—range Te 0/2,Te 0/3}
(Multicast)
Related show mac-address-table
Commands

mac-address-table station-move threshold

Change the frequency with which the MAC address station-move trap is sent after a MAC address changes in a VLAN. A
trap is sent if a station move is detected above a threshold number of times in a given interval.
C-Series, E-Series, S4810
Syntax [no] mac-address-table station-move threshold number interval
count
Parameters
threshold
interval
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.7.0
•
vlan-id
Enter the keyword vlan followed by a VLAN ID number from 1 to
4094.
Added support for output range parameter for S4810 and Z9000.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– displays the MAC address table.
number
Enter the keyword threshold followed by the number of times
MAC addresses in VLANs can change before an SNMP trap is sent.
The range is 1 to 10.
seconds
Enter the keyword interval followed by the number of seconds.
The range is 5 to 60.
Introduced on the S4810.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
1031