Stack-Unit Renumber - Dell Force10 S4810P Reference Manual

Parameters
0-11
S25N|S25P|S25V|
S50N|S50V|S4810
Defaults When this value is not set, a switch joining the stack is given the next available sequential
stack member identifier.
Command Modes CONFIGURATION
Command History
Version 7.7.1.0
Related
Commands

stack-unit renumber

Change the stack member ID of any stack member or a stand-alone S-Series.
S-Series
Syntax stack-unit 0-11 renumber 0-11
Parameters
0-11
Defaults none
Command Modes EXEC Privilege
Command History
Version 7.7.1.0
Usage
You can renumber any switch, including the management unit or a stand-alone unit.
Information
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are
renumbered, only that specific unit is reset and comes up with the new unit number.
Example
FTOS#stack-unit 5 renumber 6
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Enter a stack member identifier, from 0 to 11, of the switch that you
want to add to the stack.
Enter the S-Series model identifier of the switch to be added as a
stack member. This identifier is also referred to as the
Introduced on the S-Series.
• reload – reboots FTOS.
• show system (S-Series)
member.
The first instance of this value is the stack member unit identifier,
from 0 to 11, of the switch that you want add to the stack. The range
is: 0 to 11. The second instance of this value is the desired new unit
identifier number.
Introduced on the S-Series.
– displays the status of all stack members or a specific
provision type .
1525