Ip Ssh Authentication-Retries; Ip Ssh Connection-Rate-Limit - Dell Force10 S4810P Reference Manual

Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage To configure the switch as a SCP server, use the ip ssh server command.
Information
Related ip ssh server
Commands

ip ssh authentication-retries

Configure the maximum number of attempts that should be used to authenticate a user.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip ssh authentication-retries 1-10
Parameters
1-10
Defaults 3
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage This command specifies the maximum number of attempts to authenticate a user on a SSH
Information connection with the remote host for password authentication. SSH disconnects when the
number of password failures exceeds authentication-retries.

ip ssh connection-rate-limit

Configure the maximum number of incoming SSH connections per minute.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip ssh connection-rate-limit 1-10
1444
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enables the SSH and SCP server on the switch.
Enter the number of maximum retries to authenticate a user. The
range is 1 to 10. The default is 3.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.