Dell Force10 S4810P Reference Manual page 1221

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)
Hide thumbs Also See for Force10 S4810P:
Table of Contents

Advertisement

key-encryption-
type
key
authentication-
algorithm
key-encryption-
type
key
Defaults
Not configured.
Command Modes
INTERFACE
Command History
Version 9.1.(0.0)
Version 8.4.2.0
Usage
Before you enable IPsec encryption on an OSPFv3 interface, you must first enable IPv6 unicast
Information
routing globally, configure an IPv6 address and enable OSPFv3 on the interface, and assign the
interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or encryption) on the
router. You must configure the same encryption policy (same SPI and key) on each OSPFv3
interface in a link.
To remove an IPsec encryption policy from an interface, enter the no ipv6 ospf encryption spi
number command. To remove null authentication on an interface to allow the interface to
inherit the authentication policy configured for the OSPFv3 area, enter the no ipv6 ospf no ipv6
ospf encryption null command.
Related
area encryption
Commands
show crypto
ipsec policy
show crypto
ipsec sa ipv6
(OPTIONAL) Specifies if the key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
Text string used in authentication.
The required lengths of a non-encrypted or encrypted key are:
3DES - 48 or 96 hex digits; DES - 16 or 32 hex digits; AES-CBC -32 or 64
hex digits for AES-128 and 48 or 96 hex digits for AES-192.
Specifies the authentication algorithm to use for encryption. Valid
values are MD5 or SHA1.
(OPTIONAL) Specifies if the authentication key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
Text string used in authentication.
For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits (non-
encrypted) or 80 hex digits (encrypted).
Introduced on the S4810 and Z9000.
Introduced on the E-Series TeraScale.
Configure an IPsec encryption policy for an OSPFv3 area.
Display the configuration of IPsec encryption policies.
Display the security associations set up for OSPFv3 interfaces in
encryption policies.
1221

Advertisement

Table of Contents
loading

Table of Contents