Remote Monitoring (Rmon); Rmon Alarm - Dell Force10 S4810P Reference Manual

Remote Monitoring (RMON)

The Dell Force10 operating software (FTOS) remote monitoring (RMON) is implemented on the C-Series, E-Series, S-
Series, Z-Series, or S4810 platforms.
FTOS RMON is based on IEEE standards, providing both 32-bit and 64-bit monitoring and long-term statistics collection.
FTOS RMON supports the following RMON groups, as defined in RFC-2819, RFC-3273, and RFC-3434:
• Ethernet Statistics Table; RFC-2819
• Ethernet Statistics High-Capacity Table; RFC-3273, 64bits
• Ethernet History Control Table; RFC-2819
• Ethernet History Table; RFC-2819
• Ethernet History High-Capacity Table; RFC-3273, 64bits
• Alarm Table; RFC-2819
• High-Capacity Alarm Table (64bits); RFC-3434, 64bits
• Event Table; RFC-2819
• Log Table; RFC-2819
FTOS RMON does not support the following statistics:
• etherStatsCollisions
• etherHistoryCollisions
• etherHistoryUtilization
NOTE: Only SNMP GET/GETNEXT access is supported. Configure RMON using the RMON commands. Collected
data is lost during a chassis reboot.

rmon alarm

Set an alarm on any MIB object.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax rmon alarm number variable interval {delta | absolute} rising-
threshold value event-number falling-threshold value event-
number [owner string]
To disable the alarm, use the no rmon alarm number command.
Parameters
number
Enter the alarm integer number from 1 to 65535. The value must be
unique in the RMON alarm table.
44
1377