Show Ip Ospf Database Opaque-Area - Dell Force10 S4810P Reference Manual

show ip ospf database opaque-area

Display the opaque-area (type 10) LSA information.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip ospf process-id database opaque-area [link-state-id]
[adv-router ip-address]
Parameters
process-id
link-state-id
adv-router
address
Command Modes
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage The following describes the show ip ospf process-id database opaque-area
Information
command shown in the Example below.
Item
LS Age
Options
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
(OPTIONAL) Specify LSA ID in dotted decimal format. The LSA ID
value depends on the LSA type, and it can be one of the following:
•
•
•
ip-
(OPTIONAL) Enter the keywords adv-router and the ip-address to
display only the LSA information about that router.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the LSA's age.
Displays the optional capabilities available on router. The following
options can be found in this item:
•
•
the network's IP address for Type 3 LSAs or Type 5 LSAs
the router's OSPF router ID for Type 1 LSAs or Type 4 LSAs
the default destination (0.0.0.0) for Type 5 LSAs
TOS-capability or No TOS-capability is displayed depending
on whether the router can support Type of Service.
DC or No DC is displayed depending on whether the
originating router can support OSPF over demand circuits.
1189