Show Spanning-Tree Pvst - Dell Force10 S4810P Reference Manual

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 S4810P:

Table of Contents

After you enable PVST+, the device runs an STP instance for each VLAN it supports.

show spanning-tree pvst

View the Per-VLAN spanning tree configuration.

C-Series, E-Series, S-Series, Z-Series

show spanning-tree pvst [vlan vlan-id] [brief] [guard]

Command Modes

vlan 2 bridge-priority 4096

vlan 3 bridge-priority 16384

– disables PVST+.

– displays the PVST+ configuration.

(OPTIONAL) Enter the keyword vlan followed by the VLAN ID. The

range is 1 to 4094.

(OPTIONAL) Enter the keyword brief to view a synopsis of the

PVST+ configuration information.

(OPTIONAL) Enter one of the interface keywords along with the slot/

port information:

(OPTIONAL) Enter the keyword guard to display the type of guard

enabled on a PVST interface and the current port state.

EXEC Privilege

For a Fast Ethernet interface, enter the keyword

FastEthernet followed by the slot/port information.

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a Port Channel interface, enter the keyword port-

channel followed by a number: For the C-Series and S-

Series, the range is 1 to 128. For the E-Series, the range is 1 to

255 for TeraScale and 1 to 512 for ExaScale.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by the slot/port information.