Dot1X Auth-Server; Dot1X Guest-Vlan - Dell Force10 S4810P Reference Manual

authentication fails after all allowed attempts, the interface is moved to the authentication
failed VLAN.
After the authentication VLAN is assigned, the port-state must be toggled to restart
authentication. Authentication occurs at the next re-authentication interval (dot1x
reauthentication).
Related
dot1x port-control
Commands

dot1x guest-vlan

show dot1x interface

dot1x auth-server

Configure the authentication server to RADIUS.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax dot1x auth-server radius
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.4.1.0
dot1x guest-vlan
Configure a guest VLAN for limited access users or for devices that are not 802.1X capable.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax dot1x guest-vlan vlan-id
To disable the guest VLAN, use the no dot1x guest-vlan vlan-id command.
Parameters
vlan-id
Defaults Not configured.
Command Modes CONFIGURATION (conf-if-interface-slot/port)
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
– enables port-control on an interface.
– configures a guest VLAN for non-dot1x devices.
– displays the 802.1X information on an interface.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
Enter the VLAN Identifier. The range is 1 to 4094.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series, S-Series, and E-Series.
1435