Wanport; Port Channel Commands - Dell Force10 S4810P Reference Manual

wanport

Enable WAN mode on a TenGigabitEthernet interface.
E-Series
Syntax wanport
To disable the WAN Port, enter the no wanport command.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.1.1.2
pre-Version
6.2.1.0
Usage
The port must be in a shutdown state to change from LAN mode to WAN mode and vice-versa
Information
as shown in the Example below.
For E-Series ExaScale systems, you must configure all the ports in a port-pipe to either
WANPHY or non-WANPHY. They cannot be mixed on the same port-pipe.
Example
interface TenGigabitEthernet 13/0
FTOS(conf-if-te-13/0)#
FTOS(conf-if-te-13/0)#wanport
% Error: Port should be in shutdown mode, config ignored Te
13/0.
FTOS(conf-if-te-13/0)#
FTOS(conf-if-te-13/0)#shutdown
FTOS(conf-if-te-13/0)#
FTOS(conf-if-te-13/0)#wanport
FTOS(conf-if-te-13/0)#

Port Channel Commands

A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a single link according to
IEEE 802.3ad. In FTOS, a LAG is referred to as a Port Channel.
• For the E-Series ExaScale, the maximum port channel ID is 255 and the maximum members per port channel is
64.
• For the E-Series TeraScale, the maximum port channel ID is 255 and the maximum members per port channel is
16.
• For the C-Series, the maximum port channel ID is 128 and the maximum members per port channel is 8.
• For the S-Series, the maximum port channel ID is 128 and the maximum members per port channel is 8.
818
Introduced on the E-Series ExaScale.
Introduced on the E-Series.
no ip address
no shutdown