Dell Force10 S4810P Reference Manual page 1179

Version 8.3.8.0
Version 8.3.7.0
Version 7.9.1.0
Version 7.8.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage If you delete all the network area commands for Area 0, the show ip ospf command
Information output does not list Area 0.
The following describes the show ip ospf command shown in the Example below.
Line Beginning with
"Routing Process..."
"Supports only..."
"SPF schedule..."
"Convergence
Level"
"Min LSA...."
"Number of..."
Example
FTOS#show ip ospf 10
Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-
vrf
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 0 msec, Min LSA arrival 1000 msec
Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
Number of area in this router is 1, normal 1 stub 0 nssa 0
FTOS#
Related
show ip ospf database
Commands
show ip ospf interface
show ip ospf neighbor
show ip ospf virtual-links
Added output for LSA throttling timers.
Introduced on the S4810.
Added support for VRF.
Added support of Multi-Process OSPF.
Added the process-id option, in support of Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the OSPF process ID and the IP address associated with
the process ID.
Displays the number of Type of Service (TOS) rouse supported.
Displays the delay and hold time configured for this process ID.
Displays the intervals set for LSA transmission and acceptance.
Displays the number and type of areas configured for this process
ID.
Area BACKBONE (0)
Number of interface in this area is 1
SPF algorithm executed 205 times
Area ranges are
– displays information about the OSPF routes configured.
– displays the OSPF interfaces configured.
– displays the OSPF neighbors configured.
– displays the OSPF virtual links configured.
1179