Show System Stack-Ports - Dell Force10 S4810P Reference Manual

Auto reboot Stack-unit: Enabled
Auto failover limit:
-- Stack-unit Failover Record --
------------------------------------------------
Failover Count:
Last failover timestamp: None
Last failover Reason:
Last failover type:
-- Last Data Block Sync Record: --
------------------------------------------------
Stack Unit Config: succeeded Jul 11 2012 09:42:35
Runtime Event Log: succeeded Jul 11 2012 09:42:35
Related redundancy disable-auto-reboot
Commands

show system stack-ports

Display information about the stacking ports on all switches in the S-Series stack.
S-Series
Syntax show system stack-ports [status | topology]
Parameters
status
topology
Defaults none
Command Modes
Command History
Version 7.7.1.0
Usage The following describes the show interfaces command shown in the Example below.
Information
1522
Start-up Config: succeeded Jul 11 2012 09:42:35
Running Config: succeeded Jul 11 2012 09:42:35
ACL Mgr: succeeded Jul 11 2012 09:42:35
LACP: no block sync done
STP: no block sync done
SPAN: no block sync done
(OPTIONAL) Enter the keyword status to display the command
output without the Connection field.
(OPTIONAL) Enter the keyword topology to limit the table to just
the Interface and Connection fields.
• EXEC
• EXEC Privilege
Introduced on the S-Series.
3 times in 60 minutes
0
None
None
– prevents the system from auto-rebooting if it fails.