Snmp-Server Location; Snmp-Server Packetsize - Dell Force10 S4810P Reference Manual

Configuring Informs
To send an inform, use the following steps:
Related
snmp-server enable traps
Commands
snmp-server community

snmp-server location

Configure the location of the SNMP server.
C-Series, E-Series, S-Series, Z-Series
Syntax snmp-server location text
To delete the SNMP location, use the no snmp-server location command.
Parameters
text
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command

snmp-server packetsize

Set the largest SNMP packet size permitted. Wen the SNMP server is receiving a request or generating a reply, use the
snmp-server packetsize global configuration command.
C-Series, E-Series, S-Series, Z-Series
Syntax snmp-server packetsize byte-count
Parameters
byte-count
1492
1. Configure a remote engine ID.
2. Configure a remote user.
3. Configure a group for this user with access rights.
4. Enable traps.
5. Configure a host to receive informs.
– enables SNMP traps.
– configures a new community SNMPv1 or SNMPv2c.
Enter an alpha-numeric text string, up to 55 characters long.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter one of the following values 8, 16, 24 or 32. Packet sizes are 8000
bytes, 16000 bytes, 32000 bytes, and 64000 bytes.