Ip Pim Ingress-Interface-Map - Dell Force10 S4810P Reference Manual

To remove the access list, use the no ip pim join-filter ext-access-list
{in | out} command.
Parameters
ext-access-list
in
out
Defaults none
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.7.1.0
Example
FTOS(conf)# ip access-list extended iptv-channels
FTOS(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
FTOS(config-ext-nacl)# permit ip any 232.1.1.0/24
FTOS(config-ext-nacl)# permit ip 100.1.1.0/16 any
FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels in
FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels out
Related ip access-list extended
Commands

ip pim ingress-interface-map

When the Dell Force10 system is the RP, statically map potential incoming interfaces to (*,G) entries to create a lossless
multicast forwarding environment.
C-Series, E-Series, S-Series, S4810
Syntax ip pim ingress-interface-map std-access-list
Parameters
std-access-list
Defaults none
Command Modes INTERFACE
Command History
Version 8.3.12.0
Version 8.4.1.0
Example
FTOS(conf)# ip access-list standard map1
FTOS(config-std-nacl)# permit 224.0.0.1/24
FTOS(config-std-nacl)#exit
1240
Enter the name of an extended access list.
Enter this keyword to apply the access list to inbound traffic.
Enter this keyword to apply the access list to outbound traffic.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series for the port-channels and the S-Series.
Introduced on the E-Series.
– configure an access list based on IP addresses or protocols.
Enter the name of an standard access list.
Introduced on the S4810.
Introduced