Show Ip Ospf Routes - Dell Force10 S4810P Reference Manual

Example
FTOS#show ip ospf 34 neighbor
Neighbor ID Pri State
20.20.20.7
192.10.10.2 1 FULL/DR
20.20.20.1
FTOS#

show ip ospf routes

Display routes as calculated by OSPF and stored in OSPF RIB.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip ospf process-id routes
Parameters
process-id
Defaults none
Command Modes
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
Usage
This command is useful in isolating routing problems between the OSPF and the RTM. For
Information
example, if a route is missing from the RTM/FIB but is visible from the display output of this
command, the problem is with downloading the route to the RTM.
This command has the following limitations:
Example
FTOS#show ip ospf 100 route
Prefix
1.1.1.1
3.3.3.3
13.0.0.0
150.150.150.0
172.30.1.0
FTOS#
1200
1 FULL/DR
1 FULL/DROTHER00:00:36 192.10.10.4 Gi 0/1 0.0.0.1
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series and E-Series.
• The display output is sorted by prefixes; intra-area ECMP routes are not displayed
together.
• For Type 2 external routes, Type 1 cost is not displayed.
Cost Nexthop
1 0.0.0.0
2 13.0.0.3
1 0.0.0.0
2 13.0.0.3
2 13.0.0.3
Dead Time Address
00:00:32 182.10.10.3 Gi 0/0 0.0.0.2
00:00:37 192.10.10.2 Gi 0/1 0.0.0.1
Interface Area
Lo 0 0
Gi 0/47 1
Gi 0/47 0
Gi 0/47 -
Gi 0/47 1
Interface Area
Type
Intra-Area
Intra-Area
Intra-Area
External
Intra-Area