Wred-Profile - Dell Force10 S4810P Reference Manual

Related

wred-profile

Commands
wred-profile
Create a WRED profile and name the profile.
E-Series, Z-Series, S4810
Syntax wred-profile wred-profile-name
To remove an existing WRED profile, use the no wred-profile command.
Parameters
wred-profile-
name
Defaults The five pre-defined WRED profiles. When you configure a new profile, the minimum and
maximum threshold defaults to predefined wred_ge_g values.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
pre-Version
6.1.1.1
Usage Use the default pre-defined profiles or configure your own profile. You cannot delete the pre-
Information defined profiles or their default values. This command enables WRED configuration mode—
(conf-wred).
Related threshold
Commands
1352
– creates a WRED profile and name that profile.
Enter your WRED profile name in character format (16 character
maximum). Or use one of the pre-defined WRED profile names. You
can configure up to 26 WRED profiles plus the five pre-defined
profiles, for a total of 31 WRED profiles.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the .E-Series
– specifies the minimum and maximum threshold values of the WRED profile.