Related
msti
Commands
revision
protocol spanning-tree mstp
Enter MULTIPLE SPANNING TREE mode to enable and configure the multiple spanning tree group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
protocol spanning-tree mstp
To disable the multiple spanning tree group, use the no protocol spanning-tree
mstp command.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage
MSTP is not enabled when you enter MULTIPLE SPANNING TREE mode. To enable MSTP
Information
globally on the switch, enter the no disable command while in MULTIPLE SPANNING TREE
mode.
For more information about the multiple spanning tree protocol, refer to the
Guide .
Example
FTOS(conf)#protocol spanning-tree mstp
FTOS(config-mstp)#no disable
Related
disable
Commands
– maps the VLAN(s) to an MST instance.
– assigns the revision number to the MST configuration.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– disables multiple spanning tree.
FTOS Configuration
1107