System-Mac; Unit-Id - Dell Force10 S4810P Reference Manual

IGMP Reg Response rcvd:
IGMP PDU Tunnel Pkt sent:5
IGMP PDU Tunnel Pkt rcvd:10
IGMP Tunnel PDUs sent:
IGMP Tunnel PDUs rcvd:

system-mac

Reconfigure the default MAC address for the domain.
Z-Series, S4810
Syntax system-mac mac-address
Parameters
mac-address
Defaults Not configured.
Command Modes VLT DOMAIN
Command History
Version 9.0.0.0
Version 8.3.8.0
Usage
When you create a VLT domain on a switch, FTOS automatically creates a VLT-system MAC
Information
address used for internal system operations.
Use the system-mac command to reconfigure the default MAC address for the domain by
entering a new MAC address in the format nn:nn:nn:nn:nn:nn..
You must also reconfigure the same MAC address on the VLT peer switch.

unit-id

Explicitly configure the default unit ID of a VLT peer switch.
Z-Series, S4810
Syntax unit-id [0 | 1]
Parameters
0 | 1
Defaults Automatically assigned based on the MAC address of each VLT peer. The peer with the lower
MAC address is assigned unit 0; the peer with the higher MAC address is assigned unit 1.
1
10
19
Enter the system MAC address for the VLT domain.
Introduced on the Z9000.
Introduced on the S4810.
Configure the default unit ID of a VLT peer switch. Enter 0 for the first
peer or enter 1 for the second peer.
1609