Dell Force10 S4810P Reference Manual page 1486

notification-
option
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
Version 9.1(0.0)
Version 8.3.11.1
Version 8.3.7.0
Version 8.4.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
FTOS supports up to 16 SNMP trap receivers.
Information
For the cam-utilization notification option, the system generates syslogs and SNMP
traps when the L3 host table or route table utilization goes above the threshold. This applies to
the S4810 only.
If you do not configure this command, no traps controlled by this command are sent. If you do
not specify a notification-type and notification-option, all traps are enabled.
Related snmp-server community
Commands
1486
• snmp—Notification of RFC 1157 traps.
• stp—Notification of a state change in the spanning tree
protocol (RFC 1493).
• vlt—Notification of virtual link trunking.
• vrrp—Notification of a state change in a VRRP group.
• xstp—Notification of a state change in MSTP (802.1s),
RSTP (802.1w), and PVST+.
For the envmon notification-type, enter one of the following optional
parameters:
•
cam-utilization
•
fan
•
supply
•
temperature
For the snmp notification-type, enter one of the following optional
parameters:
•
authentication
•
coldstart
•
linkdown
•
linkup
Added support for copy-config and ecmp traps.
Introduced on the Z9000.
Introduced on the S4810.
Added support for VRRP traps.
Added support for STP and xSTP traps. Introduced on the S-Series.
Introduced on the C-Series.
– enables SNMP and sets the community string.