Dell Force10 S4810P Reference Manual page 1005

level-1
level-1-2
level-2
match {external |
internal}
route-map
name
Defaults Refer to Parameters.
Command Modes
Command History
Version 8.3.12.0
Version 7.5.1.0
Version 6.3.1.0
Usage How a metric value assigned to a redistributed route is advertised depends on how on the
Information configuration of the metric-style command. If the metric-style command is set for
Narrow mode and the metric value in the redistribute ospf command is set to a
number higher than 63, the metric value advertised in LSPs is 63. If the metric-style
command is set for wide mode, an the metric value in the redistribute ospf command
is advertised.
•
(OPTIONAL) Routes are independently redistributed into IS-IS as
Level 1 routes.
(OPTIONAL) Routes are independently redistributed into IS-IS as
Level-1-2 routes.
(OPTIONAL) Routes are independently redistributed into IS-IS as
Level 2 routes. This is the default.
(OPTIONAL) The command used for OSPF to route and redistribute
into other routing domains. The values are
•
•
map-
map-name is an identifier for a configured route map. The route map
should filter imported routes from the source routing protocol to the
current routing protocol.
If you do not specify a map-name, all routes are redistributed. If you
specify a keyword, but fail to list route map tags, no routes are
imported.
for IPv4 )
• ROUTER ISIS (
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (
Introduced on the S4810.
Added support for IPv6 ISIS.
Introduced.
internal
internal
external
for IPv6 )
1005