Spanning-Tree - Dell Force10 S4810P Reference Manual

Designated bridge has priority 32768, address 0001.e801.6aa8
Designated port id is 128.257, designated path cost 0
Number of transitions to forwarding state 1
BPDU (MRecords): sent 21, received 9
The port is not in the Edge port mode
Usage The following describes the show spanning-tree msti 5 guard command shown in
Information the Example below.
Field
Interface Name
Instance
Sts
Guard Type
Example (Guard)
FTOS#show spanning-tree msti 5 guard
Interface
Name
------------------------------------
Gi 0/1
Gi 0/2
Gi 0/3

spanning-tree

Enable the multiple spanning tree protocol on the interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax spanning-tree
To disable the multiple spanning tree protocol on the interface, use the no spanning-
tree command.
Parameters
spanning-tree
Defaults Enable.
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
1112
Description
MSTP interface.
MSTP instance.
Port state: root-inconsistent (INCON Root), forwarding (FWD),
listening (LIS), blocking (BLK), or shut down (EDS Shut).
Type of STP guard configured (Root, Loop, or BPDU guard).
Instance Sts Guard
5 INCON(Root)
5 FWD
5 EDS(Shut)
Enter the keywords spanning-tree to enable the MSTP on the
interface.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
type
Rootguard
Loopguard
Bpduguard