Show Interfaces Phy - Dell Force10 S4810P Reference Manual

show interfaces phy

Display auto-negotiation and link partner information.
C-Series, E-Series, S-Series, Z-Series
Syntax show interfaces gigabitethernet slot/port phy
Parameters
gigabitethernet
Command Modes
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 6.5.4.0
Usage The following describes the show interfaces gigabitethernet command Example
Information
below.
Mode Control
Mode Status
AutoNegotiation
Advertise
AutoNegotiation
Remote Partner's
Ability
AutoNegotiation
Expansion
1000Base-T
Control
Phy Specific
Control
Enter the keyword gigabitethernet followed by the slot/port
information.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
Indicates if auto negotiation is enabled. If so, indicates the
selected speed and duplex.
Displays auto negotiation fault information. When the interface
completes auto negotiation successfully, the autoNegComplete
field and the linkstatus field read "True."
Displays the control words advertised by the local interface during
negotiation. Duplex is either half or full. Asym- and Sym Pause is the
types of flow control supported by the local interface.
Displays the control words advertised by the remote interface during
negotiation. Duplex is either half or full. Asym- and Sym Pause is the
types of flow control supported by the remote interface
ParallelDetectionFault is the handshaking scheme in which the link
partner continuously transmit an "idle" data packet using the Fast
Ethernet MLT-3 waveform. Equipment that does not support auto-
negotiation must be configured to exactly match the mode of
operation as the link partner or else no link can be established.
1000Base-T requires auto-negotiation. The IEEE Ethernet standard
does not support setting a speed to 1000 Mbps with the speed
command without auto-negotiation. E-Series line cards support both
full-duplex and half-duplex 1000BaseT.
Values are:
801