Sflow Enable (Global) - Dell Force10 S4810P Reference Manual

The sFlow agent address is carried in a field in SFlow packets and is used by the collector to
identify the sFlow agent.
IPv6 sFlow collectors and agents are supported on E-Series (ExaScale and TeraScale), C-
Series, and S-Series routers.
As part of the sFlow-MIB, if the SNMP request originates from a configured collector, FTOS
returns the corresponding configured agent IP in the MIB requests. FTOS checks to ensure
that two entries are not configured for the same collector IP with a different agent IP. Should
that happen, FTOS generates the following error: %Error: Different agent-addr
attempted for an existing collector.

sflow enable (Global)

Enable sFlow globally.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.2.1.1
Usage sFlow is disabled by default. In addition to this command, sFlow needs to be enable on
Information individual interfaces where sFlow sampling is desired.
Related sflow enable (Interface)
Commands
Introduced on the Z9000.
Introduced on the S4810.
Introduced S-Series Stacking.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enables sFlow on Interfaces.
1469