Version 8.3.8.0
Usage
Use the peer-down-vlan parameter to configure the VLAN from where the VLT peer forwards
Information
packets received over the VLTi from an adjacent VLT peer that is down. When a VLT peer with
bare metal provisioning (BMP) is booting up, it sends untagged DHCP discover packets to its
peer over the VLTi. Use this configuration to ensure that the DHCP discover packets are
forwarded to the VLAN that has the DHCP server.
primary-priority
Assign the priority for master election among VLT peers.
S4810
Syntax
[no] primary-priority
Parameters
value
Default
32768
Command Modes
VLT DOMAIN
Command History
Version 8.3.8.0
Usage
After you configure the VLT domain on each peer switch on both sides of the interconnect
Information
trunk, by default, the FTOS software elects a primary and secondary VLT peer device. Use the
priority command to reconfigure the primary role of VLT peer switches.
show vlt brief
Displays summarized status information about VLT domains currently configured on the switch.
Z-Series, S4810
Syntax
show vlt brief
Default
Not configured.
Command Modes
EXEC
Command History
Version 9.0.0.0
Version 8.3.8.0
Introduced on the S4810.
To configure the primary role on a VLT peer, enter a lower value than
the priority value of the remote peer. The range is 1 to 65535.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the S4810.
1603