Tacacs-Server Host - Dell Force10 S4810P Reference Manual

Version 7.5.1.0
pre-Version
6.2.1.1

tacacs-server host

Specify a TACACS+ host.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax tacacs-server host {hostname | ipv4-address | ipv6-address}
[port number] [timeout seconds] [key key]
Parameters
hostname
ipv4-address |
ipv6-address
port
timeout
key
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.4.1.0
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage
To list multiple TACACS+ servers to be used by the aaa authentication login
Information
command, configure this command multiple times.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the name of the TACACS+ server host.
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of the
TACACS+ server host.
number
(OPTIONAL) Enter the keyword port followed by a number as the
port to be used by the TACACS+ server. The range is zero (0) to 65535.
The default is 49.
seconds
(OPTIONAL) Enter the keyword timeout followed by the number of
seconds the switch waits for a reply from the TACACS+ server. The
range is 0 to 1000. The default is 10 seconds.
key
(OPTIONAL) Enter the keyword key followed by a string up to 42
characters long as the authentication key. This authentication key
must match the key specified in the tacacs-server key for the
TACACS+ daemon.
Introduced on the Z9000.
Added support for IPv6.
Introduced on the S4810.
Authentication key length increased to 42 characters.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1431