Stack-Unit Stack-Group - Dell Force10 S4810P Reference Manual

Related
Commands

stack-unit stack-group

Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the unit is
assigned to the correct group.
S4810
Syntax stack-unit unit-id stack-group stack-group-id
To remove the current stack group configuration, use the no stack-unit unit-id
stack-group stack-id command.
Parameters
unit-id
stack-group-id
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0
Version 8.3.10.2
Usage The following message displays to confirm the command.
Information
1526
• reload – reboots FTOS.
• reset stack-unit – resets the designated S-Series stack member.
• show system (S-Series)
member.
Enter the stack unit ID.
Enter the stack group ID. The range is 0 to 1615.
Reset command mode from EXEC to CONFIGURATION.
Introduced on the S4810.
WARNING: Setting ports Fo 0/60 as stack group will make their interface configs obsolete
after a reload.[confirm yes/no]: If "y" is entered, all non-default configurations on any
member ports of the current stack group will be removed when the unit is rebooted.
NOTE: Any scripts used to streamline the stacking configuration process must be updated
to reflect the Command Mode change from EXEC Privilege to CONFIGURATION to allow
the scripts to work correctly.
– displays the current status of all stack members or a specific