Ipv6 Control-Plane Icmp Error-Rate-Limit - Dell Force10 S4810P Reference Manual

Version 8.3.7.0
Version 8.4.1.0
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
Usage
Information
Example
FTOS(conf)#interface gigabitethernet 10/0
FTOS(conf-if-gi-10/0)#ipv6 address ?
X:X:X:X::X IPv6 address
FTOS(conf-if-gi-10/0)#ipv6 address 2002:1:2::3 ?
<0-128> Prefix length in bits
FTOS(conf-if-gi-10/0)#ipv6 address 2002:1:2::3 /96 ?
<cr>
FTOS(conf-if-gi-10/0)#ipv6 address 2002:1:2::3 /96
FTOS(conf-if-gi-10/0)#show config
!
interface GigabitEthernet 10/0
FTOS(conf-if-gi-10/0)#

ipv6 control-plane icmp error-rate-limit

Configure the maximum number of ICMP error packets per second that can be sent per second.
S4810
Syntax ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-rate-
limit command.
Parameters
pps
938
Introduced on the S4810.
Added support on the management Ethernet port.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
• If two addresses are configured, you must delete an existing address before
configuring a new address.
• If the last manually-configured global IPv6 address is removed using the "no" form of
the command, the link-local IPv6 address is removed automatically.
• IPv6 addresses on a single management interface cannot be members of the same
subnet.
• IPv6 secondary addresses on management interfaces across platform must be
members of the same subnet.
• IPv6 secondary addresses on management interfaces should not match the virtual IP
address and should not be in the same subnet as the virtual IP.
no ip address
ipv6 address 2002:1:2::3 /96
no shutdown
Enter the maximum number of error packets to be generated per
second. The range is 1 to 200, where 0 disables the rate-limiting.