Change Circuit Packs - Avaya S8700 Maintenance Manual

Maintenance Commands

change circuit packs

change circuit-packs UU
This command allows the user to administratively add, change or remove circuit
packs that are to be inserted into port, expansion control, and switch node
carriers. It is used to configure the system when the circuit packs have not yet
been physically inserted. This command does not support displaying or modifying
the boards in the PPN control carrier.
Parameters
UU The number of the cabinet containing the circuit packs to be modified. Default is 1.
For S8700 IP Connect configurations, the number applies to port slots 1-10 only.
Output
The following display shows a typical result when change circuit-packs is
entered for Cabinet 1. The following five screens were taken from an S8700
Multi-Connect configuration.
change circuit-packs
Cabinet: 1
Cabinet Layout: five-carrier
Slot Code Sf Mode
01: TN570 D
02:
03: TN464 G
04: TN2198
05: TN748 D
06: TN464 F
07: TN464 G
08: TN464 F
09: TN464 F
10: TN464 F
'#' indicates circuit pack conflict.
7-56 Issue 1 May 2002
CIRCUIT PACKS
Carrier Type: expansion-control
Name Slot Code
EXPANSION INTF
DS1 INTERFACE
BRI LINE
TONE DETECTOR
DS1 INTERFACE
DS1 INTERFACE
DS1 INTERFACE
DS1 INTERFACE
DS1 INTERFACE
Carrier: A
Sf Mode Name
11: TN799 C CONTROL-LAN
12:
13:
14: TN754 C DIGITAL LINE
15: TN793 B ANALOG LINE
16:
17:
18: TN767 E DS1 INTERFACE
19:
Page 1 of 5
555-233-143