Atm Vc-Per-Vp - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
atm vc-per-vp
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
atm vc-per-vp [ vcCount ]
no atm vc-per-vp
Command introduced before JunosE Release 7.1.0.
Configures the number of virtual circuits per virtual path. This command controls the VPI
and VCI range on the ATM interface. The allowable configuration range depends on the
line module. The router will not execute the command if any virtual circuits are open on
the interface. The no version restores the default.
NOTE: This command is not available for ATM interfaces on the E120 router and the
E320 router because they support the entire VPI/VCI range.
The minimum number of VCs per VP is 4096 for OC3-4 modules and 1024 for T3 ATM
modules. If you enter a value that is below the minimum, the router uses the minimum
value.
VCs and VP tunnels must not exist when you issue this command. If they do, you must
delete the VC and VP tunnel configuration before you issue this command.
vcCount—Number of virtual circuits per virtual path
Interface Configuration
Chapter 2: A Commands
187
Advertisement
Table of Contents
