Atm Oam - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

atm oam

atm oam [ vpi ] [ [ seg-loopback | end-loopback [ loopback-timer time ] ]
Syntax
[ cc { source | sink | both } ] ]
no atm oam [ vpi ] [ [ seg-loopback | end-loopback [ loopback-timer time ] ] ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures F4 OAM on an interface or circuit. The no version deletes F4 OAM circuits.
Description
NOTE: If you do not specify any options, both F4 end-to-end OAM and F4 segment
OAM are enabled on all VPIs on the interface.
Options
Interface Configuration, Subinterface Configuration
Mode
vpi VPI on which you want to enable F4 OAM. If you do not specify a VPI, F4
OAM flow is enabled on all VPIs on the interface.
seg-loopback Enables F4 segment OAM
end-loopback Enables F4 end-to-end OAM
loopback-timer To generate F4 loopback cells on the VPI, you must configure
the loopback timer; you can set the loopback timer only for end-to-end loopback
time Time interval in the range 1–600 seconds between transmissions of F4
loopback cells.
cc Enables CC cells on the PVC; you can enable CC cells only on data circuits,
not on control circuits, such as ILMI or signaling circuits
sink Enables this VC as a sink point (cell receiver)
source Enables this VC as the source point (cell generator)
both Enables this VC as both a sink point and a source point
Chapter 2: A Commands
177
atm oam