Atm Bulk-Config Modify - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

atm bulk-config modify

atm bulk-config bulkConfigName modify vc-range vpiStart vpiEnd vciStart vciEnd
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Modifies the VC subrange values for the specified bulk configuration VC range. If the
Description
new subrange encompasses previously configured subranges within that range, those
subranges are merged into the new one, freeing subrange resources. There is no no
version.
Options
Interface Configuration
Mode
162
atm bulk-config modify
bulkConfigName Name of the VC range; string of up to 80 characters
vpiStart Starting virtual path identifier (inclusive) of the VC subrange you are
configuring
vpiEnd Ending virtual path identifier (inclusive) of the VC subrange you are
configuring
vciStart Starting virtual circuit identifier (inclusive) of the VC subrange you are
configuring
vciEnd Ending virtual circuit identifier (inclusive) of the VC subrange you are
configuring