Address Priority - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

address priority

[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
Syntax
priority intfPriority
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the router priority. Used in determining the designated router for the particular
Description
network. This designation only applies to multi-access networks. Every broadcast
and nonbroadcast multiaccess network has a designated router. The no version
restores the default value.
NOTE: You must issue the address area command before issuing this command.
Options
Router Configuration
Mode
102
address priority
ipAddress OSPF interface address previously specified with the address
command
unnumbered Indicates that OSPF is running on an unnumbered interface
previously specified with the address command
interfaceType Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
intfPriority Priority value, an 8-bit number in the range 1–255; default value
is 1