Address Authentication Mode - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

address authentication mode

address { ipAddress | unnumbered interfaceType interfaceSpecifier }
Syntax
authentication mode { text | md5 keyID }
no address [ ipAddress | unnumbered interfaceType interfaceSpecifier ]
authentication mode
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the type of authentication used on this interface. The no version removes
Description
authentication from the interface. Supported only in RIP version 2. Authentication
is disabled by default.
Options
Address Family Configuration, Router Configuration
Mode
90
address authentication mode
ipAddress Address of IP interface where RIP will be run
unnumbered Specifies RIP will be run on an unnumbered interface
interfaceType Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
text Simple text password is sent with each RIP message. If the password is
not possessed by neighbors, the message is rejected.
md5 MD5 message-digest algorithms are used to encrypt and compress the
RIP message.
keyID Number identifying the MD5 key. Neighbors must share the MD5 key to
decrypt the message and encrypt the response.