Adapter Accept - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

adapter accept

adapter accept adapterSpecifier
Syntax
Command introduced in JUNOSe Release 7.1.0.
Release Information
Erases from NVS the type and configuration of the previous I/O adapter (IOA) in the
Description
specified IOA bay, and allows you to configure a new IOA. Issue this command after
you have installed a different type of IOA in an IOA bay. You can use this command
only when the state of the IOA is not present or disabled (mismatch). There is no no
version.
NOTE: Issuing this command reboots the line module associated with the IOA, but
it does not accept its configuration.
To accept the configuration of the line module and its associated IOAs, issue the slot
accept command.
Options
Global Configuration
Mode
adapterSpecifier Particular IOA in the format slot/adapter:
slot Number of the chassis slot; for E120 routers, in the range 0–5; for
E320 routers, in the range 0–5 or 11–16
adapter Identifier for the IOA within the chassis slot, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
Chapter 2: A Commands
81
adapter accept