Removing Addresses Or Ports From A Group - 3Com LANPLEX 6000 User Manual

Address group
example
Port group example
Removing
Addresses or
Ports from a
Group
Top-Level Menu
system
display
ethernet list
mode
list
fddi display
ipFragmentation
display
tokenring create
ipxSnapTranslation
create
delete
bridge
addressThreshold
delete
edit
ip
agingTime
copy
load
snmp
stpState
addAddress
assign
analyzer
stpPriority
removeAddress
unassign
script
stpMaxAge
addressGroup
logout
stpHelloTime
portGroup
stpForwardDelay
port
packetFilter
For port groups, entering an invalid port specification results in error
messages, similar to those described on page 15-5.
An example of adding addresses to a group follows. In the example, two
additional addresses are added to the Development address group.
Select address group to be modified [1-4]:
Adding addresses to group 2 - Development
Enter the addresses to be added - type q to return to the menu:
08-21-42-62-98-ab
Address:
Address: 08-37-21-65-78-c4
q
Address:
The example below shows a port successfully added to the Manufacturing
port group.
Select port group to be modified [1-4]:
Adding ports to group 2 - Manufacturing
Enter the ports to be added - type q to return to the menu:
Ethernet 3
Port:
q
Port:
When removing addresses or ports from a group, you can either enter the
addresses or groups at the prompts, or import them from a file. At least one
group must exist to remove an address or port.
To remove addresses or ports from an address group:
1 From the top level of the Administration Console, enter the following to
remove addresses from an address group:
bridge packetFilter addressGroup removeAddress
Or enter the following to remove ports from a port group:
bridge packetFilter portGroup removePort
2 Enter the number of the group to modify.
3 Enter the addresses or ports to remove from the new group. Type
entering all the addresses or ports.
Enter the addresses in MAC format as:
xx-xx-xx-xx-xx-xx

Removing Addresses or Ports from a Group

2
15-9
2
after
q