Dot1X Retry; Dot1X Supp-Proxy-Check - 3Com S7906E Command Reference Manual

[Sysname] dot1x quiet-period

dot1x retry

Syntax
dot1x retry max-retry-value
undo dot1x retry
View
System view
Default Level
2: System level
Parameters
max-retry-value: Maximum number of attempts to send an authentication request to a supplicant, in the
range 1 to 10.
Description
Use the dot1x retry command to set the maximum number of attempts to send an authentication
request to a supplicant.
Use the undo dot1x retry command to restore the default.
By default, the authenticator can send an authentication request to a supplicant twice at most.
Note that after sending an authentication request to a supplicant, the authenticator may retransmit the
request if it does not receive any response at an interval specified by the username request timeout
timer or supplicant timeout timer. The number of retransmission attempts is one less than the value set
by this command.
Related commands: display dot1x.
Examples
# Set the maximum number of attempts to send an authentication request to a supplicant as 9.
<Sysname> system-view
[Sysname] dot1x retry 9

dot1x supp-proxy-check

Syntax
In system view:
dot1x supp-proxy-check { logoff | trap } [ interface interface-list ]
undo dot1x supp-proxy-check { logoff | trap } [ interface interface-list ]
In Ethernet interface view:
dot1x supp-proxy-check { logoff | trap }
undo dot1x supp-proxy-check { logoff | trap }
1-14