Timer Response-Timeout (Hwtacacs Scheme View) - 3Com S7906E Command Reference Manual

Parameters
minutes: Real-time accounting interval in minutes. It is a multiple of 3 in the range 3 to 60 and defaults to
12.
Description
Use the timer realtime-accounting command to set the real-time accounting interval.
Use the undo timer realtime-accounting command to restore the default.
Note that:
For real-time accounting, a NAS must transmit the accounting information of online users to the
HWTACACS accounting server periodically. This command is for setting the interval.
The setting of the real-time accounting interval somewhat depends on the performance of the NAS
and the HWTACACS server: a shorter interval requires higher performance. You are therefore
recommended to adopt a longer interval when there are a large number of users (more than 1000,
inclusive). The following table lists the recommended ratios of the interval to the number of users.
Table 3-2 Recommended ratios of the accounting interval to the number of users
1 to 99
100 to 499
500 to 999
1000 or more
Examples
# Set the real-time accounting interval to 51 minutes for HWTACACS scheme hwt1.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] timer realtime-accounting 51

timer response-timeout (HWTACACS scheme view)

Syntax
timer response-timeout seconds
undo timer response-timeout
View
HWTACACS scheme view
Default Level
2: System level
Parameters
seconds: HWTACACS server response timeout period in seconds. It ranges from 1 to 300 and defaults
to 5.
Number of users Real-time accounting interval (minute)
3
6
12
15 or more
3-16