Igmp Snooping Configuration Commands; Display Igmp-Snooping Configuration; Display Igmp-Snooping Group - 3Com 5500G-EI Command Reference Manual

IGMP Snooping
Configuration
Commands
display igmp-snooping
configuration
display igmp-snooping
group
This section describes how to use the Internet Group Management Protocol
(IGMP) configuration commands on your Switch 5500G-EI.
Syntax

display igmp-snooping configuration

View
All views
Parameter
None
Description
Use the
display igmp-snooping configuration
Snooping configuration information.
This command is used to display the IGMP Snooping configuration information of
the Switch. The information displayed includes whether IGMP Snooping is
enabled, router port timeout, maximum response timeout of a query and the
member port timeout.
Related command:
igmp-snooping.
Example
Display the IGMP Snooping configuration information of the Switch.
<SW5500>display igmp-snooping configuration
Enable IGMP-Snooping.
The router port timeout is 105 second(s).
The max response timeout is 10 second(s).
The member port timeout is 260 second(s).
The information above tells us that: IGMP Snooping is enabled; the router port
timer is set to be 105 seconds; the max response timer is set to be 10 seconds; the
aging timer of multicast group member is set to be 260 seconds.
Syntax
display igmp-snooping group [ vlan
View
All views
Parameter
Specifies the VLAN where the multicast group to be viewed is
vlan_id
vlan :
located. When the parameter is omitted, the command will display the
information about all the multicast groups on the VLAN.

IGMP Snooping Configuration Commands

command to view the IGMP
vlan_id
]
237