Pto Switch; Key Switch - New Holland WORKMASTER 35 Operator's Manual

PTO switch

NOTICE: Most rear PTO equipment is designed to oper-
ate efficiently at 540 RPM ± 10 RPM. The tachometer is
marked to indicate 540 PTO RPM. If the needle registers
above the 540 RPM RPM mark, this indicates a danger-
ous over speed condition, and the engine RPM should be
reduced immediately.
The PTO switch (1) is located on the right-hand side of
the dash panel.
NOTE: To start the engine the PTO switch must be placed
in the "OFF" position
To activate the PTO, push down on the PTO switch and
turn the switch to the "ON" position (2).
NOTE: When the PTO is engaged the PTO indicator light
will be illuminated on the instrument panel.
To disengage the PTO, push down on the PTO switch and
the switch will automatically return to the "OFF" position
(3).

Key switch

The key switch (1) is located on the right-hand side of the
rear hood panel. Turning the key to the middle "ON" posi-
tion (2) activates the warning lights, instruments, and pre-
heat system. The engine starts when the key is turned to
the extreme right "START" position (3). A internal spring
returns the key to the middle "ON" position when released.
Turning the key to the extreme left "STOP" position (4) will
shut the engine off.
3 - CONTROLS AND INSTRUMENTS
3-10
1
NHIL12CT00670AA
1
NHIL12CT00692AA